Sleeve with band at top of cap .

1) Trace sleeve foundation; then make sections A to D 2” wide at top, 1-1/2” wide at bottom, and about 1” long.
2) Draw the remaining dotted lines as illustrated and mark sections E to J.
Slash center of sleeve from top down between B and C and across to the sides; then slash into the lower curved lines of sections A to D, and up to the top, and spread as shown in diagram 3.
3) Build up sleeve cap.
4) Allow seams to complete the sleeve.

 Sleeve with band and 3 pleats at top of cap

Use the sleeve with the band at top [sleeve 4] as a guide, and trace.
Divide cap into 4 equal parts and mark dots.
2) First draw center line down 2” long; then draw remaining dotted lines as illustrated, and mark sections A to E.
3) Slash on dotted lines and spread, raising sections B and C, 2” above E, and spreading evenly at top for the pleats.
4) Indicate the pleats at top with notches. Allow seams to complete the sleeve.

 

Sleeve with slash gathers at top

1) Trace sleeve foundation and mark position for band; then draw lines to the sides.
2) Divide the band below J into 3 equal parts; then draw the remaining lines. Mark section A to K.
3) Slash along the band lines from top down, and to the sides; then spread as illustrated, raising sections J, 2”, and making the top lines above A and E, 2” long.
4) Allow seams and make corresponding notches.